neptune pmup

Joined
Aug 25, 2015
Messages
409
Likes
19
Points
16
Location
Chino Hills
#1
hi guys, so i just got the Practical Multi-Purpose Utility Pump. plugged it in the 1-link and i cant see t in fusion.
looked around online and it says it should come up as LINKA_4_1 and LINKB_4_2. but im not seeing anything on fusion. tried looking in the unsed tab section and not seeing anything.

i have 2 1-link and have tried plugging it both boxes and nothing is coming up.
any help is appreciated
thanks
 
Joined
Aug 25, 2015
Messages
409
Likes
19
Points
16
Location
Chino Hills
#2
nvm found out, incase anyone is having the same problem.
Follow these steps.

1 Disconnect the 1Link from the apex by removing the aquabus cable and power supply. Wait for 30 seconds to a minute.
2 Disconnect both WAV pumps from the 1Link
3 Go into apex classic dash and delete the 1Link module as well as any WAV module showing the "Module Setup Page"
4 Connect the 1Link Aquabus cable into the 1Link and wait for a solid green status light
5 Go into module setup page and update the 1Link module firmware, wait for this to complete successfully
6 Plug in the power supply to the 1Link
7 Connect 1 Wav pump to the 1Link, wait to make sure it shows up in "Module Setup Page"
8 Update the Wav Modules firmware
9 Plug in 2nd Wav pump to 1link. Make sure it shows up in "Module Setup Page", update Wav firmware


Using your Apex Display to get the IP Address

1 To find your Apex IP address you use the display module.
2 Press the center button on your display module to access the Main Menu
3 Go to Main Menu> System> Net Setup> IP Address
4 There is your IP Address
5 type the IP address in your url
6 default user/pass is admin 1234
 
Top