So I got this acrylic wetdry sump a while back and been trying to figure out the best way to make the most out of it....
I have since cut out the center divider (it would have been useless to me) as well as some other flanges scattered around the tank...
I am at the point where I need to cut my baffles and glue them (weldon) to the sump.
My question is really... which blade on my table saw works best? finish blade? Is it easier to just use a cut off blade on the router and set it up with a guide?
Any thoughts or help would be greatly appreciated!
Thanks in advance...
I have since cut out the center divider (it would have been useless to me) as well as some other flanges scattered around the tank...
I am at the point where I need to cut my baffles and glue them (weldon) to the sump.
My question is really... which blade on my table saw works best? finish blade? Is it easier to just use a cut off blade on the router and set it up with a guide?
Any thoughts or help would be greatly appreciated!
Thanks in advance...
