I'm starting to mess with my calcium reactor and I'd like to get some thoughts on how to program my solenoid.
Below is what I came up with based on some threads....And my running the CaribSea Arm Media Coarse
Fallback OFF
Set OFF
If pH2 > 06.50 Then ON << This is where I want the pH at
If pH2 < 06.40 Then OFF << This turns off if it goes below 6.40
If pH < 07.79 Then OFF << This turns off the solenoid if the tank pH drops too low
Defer 005:00 Then ON << After turning off, waits five minutes to turn on again (not sure about this part)
Other possible pH values
6.55-6.65PH or 6.4-6.5
Any thoughts or suggestions are highly appreciated!
Below is what I came up with based on some threads....And my running the CaribSea Arm Media Coarse
Fallback OFF
Set OFF
If pH2 > 06.50 Then ON << This is where I want the pH at
If pH2 < 06.40 Then OFF << This turns off if it goes below 6.40
If pH < 07.79 Then OFF << This turns off the solenoid if the tank pH drops too low
Defer 005:00 Then ON << After turning off, waits five minutes to turn on again (not sure about this part)
Other possible pH values
6.55-6.65PH or 6.4-6.5
Any thoughts or suggestions are highly appreciated!