Changing an ATI Powermodule ballast

Joined
Jan 17, 2010
Messages
1,119
Likes
37
Points
38
Location
San Gabriel
#1
I am changing the ballast on my Powermodule and I need some help. I watched th video on how to change them out and it makes sense but I don't know which one to change? The schematic on the ballast makes it look like they are all connected. I am sure I am missing something simple.

Thanks.
 
Joined
Jan 17, 2010
Messages
1,119
Likes
37
Points
38
Location
San Gabriel
#3
6 bulb. I realized it wasn't set up the way i expected. I expected two ballasts, one for the two bulbs and one for the four. At this point I am not even sure the problem was the ballast. All of the lights worked but one of them occasionally didn't fire up right away and seemed dim. If only one bulb was a problem could the ballast have been bad?

When I got it apart the wires were too short to come through and two of them (yellow ) came off of the ballast. I don't know which one goes where.

Not quite sure what to do at this point.
 

Latest posts

Top