hi guys, so i just got the Practical Multi-Purpose Utility Pump. plugged it in the 1-link and i cant see t in fusion.
looked around online and it says it should come up as LINKA_4_1 and LINKB_4_2. but im not seeing anything on fusion. tried looking in the unsed tab section and not seeing anything.
i have 2 1-link and have tried plugging it both boxes and nothing is coming up.
any help is appreciated
nvm found out, incase anyone is having the same problem.
Follow these steps.
1 Disconnect the 1Link from the apex by removing the aquabus cable and power supply. Wait for 30 seconds to a minute.
2 Disconnect both WAV pumps from the 1Link
3 Go into apex classic dash and delete the 1Link module as well as any WAV module showing the "Module Setup Page"
4 Connect the 1Link Aquabus cable into the 1Link and wait for a solid green status light
5 Go into module setup page and update the 1Link module firmware, wait for this to complete successfully
6 Plug in the power supply to the 1Link
7 Connect 1 Wav pump to the 1Link, wait to make sure it shows up in "Module Setup Page"
8 Update the Wav Modules firmware
9 Plug in 2nd Wav pump to 1link. Make sure it shows up in "Module Setup Page", update Wav firmware
Using your Apex Display to get the IP Address
1 To find your Apex IP address you use the display module.
2 Press the center button on your display module to access the Main Menu
3 Go to Main Menu> System> Net Setup> IP Address
4 There is your IP Address
5 type the IP address in your url
6 default user/pass is admin 1234
There are currently 1 users browsing this thread. (0 members and 1 guests)