Hey Guys,
If you have an Apex and are using Fusion (for sure Fusion not sure about classic) check your settings, and then double check and triple check.
When they updated Fusion recently it changed my 220v heater outlet to a CO2 outlet.
It also changed the alarm points for 2 of my pH probes to 10.99
When I discovered the errors I made the corrections and told Fusion to update. The little bar went across the screen and turned Green - No Errors.
But then it turns out it was still set to 10.99 -
It took 6 cycles -- WITHOUT ANY ERRORS before the issue corrected.
Also in the past 6 weeks, my Apex no longer registers the power being out to the EB8's
Then yesterday someone else contacted me - There DOS units were set to be dosing 22ml of one channel and 12ml on another channel.
One of the channels was set to 750ml and the other 75.
A totally different Apex - at a different location - again took multiple cycles of correcting the doses with Fusion accepting it but still not correcting the erroneous value.
These are some pretty catastrophic issues. Please be careful - If you make any adjustments to any of your settings - pH, dosing, temp values for your heaters -- go double check them.
And if you find something wrong.... Make the correction and keep double checking that the correction takes hold. And if you find a hiccup and you get it corrected go back and check again 30 mins later just to be sure.
And just for the heck of it, after reading this post take some time and check that all your outlets are still set correctly - Make sure that your heater is using the right probe for temp. Make sure your heater outlet is still set as a heater outlet. And other outlets as well.
Dave B
If you have an Apex and are using Fusion (for sure Fusion not sure about classic) check your settings, and then double check and triple check.
When they updated Fusion recently it changed my 220v heater outlet to a CO2 outlet.
It also changed the alarm points for 2 of my pH probes to 10.99
When I discovered the errors I made the corrections and told Fusion to update. The little bar went across the screen and turned Green - No Errors.
But then it turns out it was still set to 10.99 -
It took 6 cycles -- WITHOUT ANY ERRORS before the issue corrected.
Also in the past 6 weeks, my Apex no longer registers the power being out to the EB8's
Then yesterday someone else contacted me - There DOS units were set to be dosing 22ml of one channel and 12ml on another channel.
One of the channels was set to 750ml and the other 75.
A totally different Apex - at a different location - again took multiple cycles of correcting the doses with Fusion accepting it but still not correcting the erroneous value.
These are some pretty catastrophic issues. Please be careful - If you make any adjustments to any of your settings - pH, dosing, temp values for your heaters -- go double check them.
And if you find something wrong.... Make the correction and keep double checking that the correction takes hold. And if you find a hiccup and you get it corrected go back and check again 30 mins later just to be sure.
And just for the heck of it, after reading this post take some time and check that all your outlets are still set correctly - Make sure that your heater is using the right probe for temp. Make sure your heater outlet is still set as a heater outlet. And other outlets as well.
Dave B