Alk consumption
- Thread starter solitude127
- Start date
Seems like a pretty fast drip rate. For comparison... I run 20mL/min with 6.6pH, but my demand is very low right now. With that high of a drip rate, you must be going through lots of co2 to maintain 6.5pH. If the media is not old, I would make sure pH meter is on calibration, lower pH for better media melt. Is this a new setup or has it been dialed a while? Tell us more about your calcium demand and other dosing methods.
Calcium reactor will do both calcium and alk supplementation. Dial it in to hold your alk stable. Dose cal and/or alk manually To where you want to levels at, if they are too far off. Then reactor should do the work. Do test weekly to ensure its maintaining all where you want it.
Calcium reactor will do both calcium and alk supplementation. Dial it in to hold your alk stable. Dose cal and/or alk manually To where you want to levels at, if they are too far off. Then reactor should do the work. Do test weekly to ensure its maintaining all where you want it.
