Drivers should run on alternating current. In our case 120Vac. you can just used an old wall wart for your fans, must have 1 laying around somewhere.
it depends on the lens angle, and the height you hang your leds.
for calcium 20x20 = 400ppm calcium almost right on target.
20 drops for alk? this seems wrong unless its a newer model that im not aware of. the one i used uses 1 drop per 1 dkh.
with 2 RO membrane i use to boost at 80psi and get 1:1 ratio, however i read that its bad for the fittings and i just went 75 psi and still pretty close to 1:1 ratio. booster pump ftw!
no problem! theres lots of stuff i cant do =]
thanks. the seams are good because i did a lot of prep work to get them smooth with no saw blade marks. with the saw blade marks they tend to bubble up and would leave a mess. i didnt even bother to flame polish the edges because its just sitting...
I used 1/4" RO line and 1/4" RO bulkhead that is screwed onto the bottom of the RO reservoir. There is a float valve in the sump. as water level drops in the sump the float valve drops thus causing the water from the water reservoir to drop into the sump until float valve floats up again and...