Drain question...
Do yall recommend a true union ball valve on drain set ups? Or a gate valve with unions added on either side (can't seem to find gate valves with unions attached)?
I understand that gates are easier to fine tune your system but is it really necessary?
How about colored PVC?
Also 2 of the holes drilled are 2" in diameter thus a 1 1/4" bulkhead will fit. I dont not see that 1 1/4" parts are as readily available. Is this size I should stay away from? Should I just use 1"?
Sent from my SM-N960U using Tapatalk
Do yall recommend a true union ball valve on drain set ups? Or a gate valve with unions added on either side (can't seem to find gate valves with unions attached)?
I understand that gates are easier to fine tune your system but is it really necessary?
How about colored PVC?
Also 2 of the holes drilled are 2" in diameter thus a 1 1/4" bulkhead will fit. I dont not see that 1 1/4" parts are as readily available. Is this size I should stay away from? Should I just use 1"?
Sent from my SM-N960U using Tapatalk
