Finally upgraded my fish shed so selling my old one:
Its a rubbermaid shed 32"deep x 55"W x 77" tall in excellent condition. East facing so only gets a little morning sun.
Lined with 1.5" foil faced EPS foam sheets. 3" hole cut in the back for pass through into the house.
4x 1/4" holes drilled on left side for RODI tubing. Source, waste flush water etc. I also ran my sprinkler wiring through for the control unit.
Includes stand made with 4x4 lumber and painted white. I made this super beefy thinking I was going to put more weight on it.
2x 15g water storage containers 30g total. I used this for my ATO storage so they're clean. RODI fills the left container from the top and also has a float valve shutoff. Both containers are connected at the bottom for balanced filling. I also added a valve in the middle for easy access to rodi water. Right container has a Apex MPUMP V2 already plumbed with siphon break. Included if you have an Apex. (requires FFM module with PS to run, not included)
Finally 50g salt water mixing tank on the bottom. Used to be my old sump. I removed a couple baffles/weirs so it fills/drains evenly. Tank only no mixing pumps.
I will also include the 3" carbine bit hole cutting saw. Used once for this project. I think I have left over 3" ABS pipe too.
No other accessories in the pictures are included just reference for how i had it setup.
I suppose you could take this apart but really recommend a pickup truck or similar to transport as assembled because i also added a bead of silicone to most of the seams.
Buyer also has 1st right of refusal for a 2nd rubbermaid shed same shape and size but no insulation and has wood shelves screwed into it. Its just way more used and weathered. Good for dry goods and equipment. (not pictured)
$400 obo. pick up 91355
Its a rubbermaid shed 32"deep x 55"W x 77" tall in excellent condition. East facing so only gets a little morning sun.
Lined with 1.5" foil faced EPS foam sheets. 3" hole cut in the back for pass through into the house.
4x 1/4" holes drilled on left side for RODI tubing. Source, waste flush water etc. I also ran my sprinkler wiring through for the control unit.
Includes stand made with 4x4 lumber and painted white. I made this super beefy thinking I was going to put more weight on it.
2x 15g water storage containers 30g total. I used this for my ATO storage so they're clean. RODI fills the left container from the top and also has a float valve shutoff. Both containers are connected at the bottom for balanced filling. I also added a valve in the middle for easy access to rodi water. Right container has a Apex MPUMP V2 already plumbed with siphon break. Included if you have an Apex. (requires FFM module with PS to run, not included)
Finally 50g salt water mixing tank on the bottom. Used to be my old sump. I removed a couple baffles/weirs so it fills/drains evenly. Tank only no mixing pumps.
I will also include the 3" carbine bit hole cutting saw. Used once for this project. I think I have left over 3" ABS pipe too.
No other accessories in the pictures are included just reference for how i had it setup.
I suppose you could take this apart but really recommend a pickup truck or similar to transport as assembled because i also added a bead of silicone to most of the seams.
Buyer also has 1st right of refusal for a 2nd rubbermaid shed same shape and size but no insulation and has wood shelves screwed into it. Its just way more used and weathered. Good for dry goods and equipment. (not pictured)


$400 obo. pick up 91355
Last edited: