Help with apex fusion and mp10 using wxm.

[SandStorm]

Ok guys, I was able the two to communicate using wxm. But on my fusion it say constant speed even though I made changes on the drop down option to reef crest and pulse mode. What am I doing wrong why it's always on constant speed...



This it what I see



Middle row. Below condx graph.

Also on my mp10 has green light.


This first time programming drive me nuts... Input needed. Thanx in advance peeps.

 

[Confuse]

Are you programming the master pump and setting the other as slave?

 

[SandStorm]

Are you programming the master pump and setting the other as slave?

No, this is one pump only

 

[babyjess210]

No more reeflink buddy???

 

[SandStorm]

No more reeflink buddy???

I still do Jess. I just got piss when they did firmware update and mine didn't work for a month until they sent me replacement. I like apex better though until I resove this little headache.

 

[SandStorm]

Anyone else have solution out there?

 

[xmas_one]

Look on YouTube, there's a boatload of apex how to videos on there.

 

[Confuse]

Maybe unplug and plug in the controller again?

Maybe try to reset the master/slave configuration on the vortech controller....I know you only have one, but it might be worth a try.

 

[SandStorm]

Thanx for the help guys... Found my bug problem..... It was one of the code in advance setting that block my program... I know it's something small but can't find the little bug problem until I went though and check each code.