Tank is 72" x 26 x 24" Crystal Dynamic euro braced tank. Custom steel blue powder-coated stand that has no vertical cross-members that get in the way.
Our tank and sump carry 200gallons (+/- 5 gallons) after rock displacement.
Equipment:
2 x Various 6 pumps each with a devoted return.
40 W and 25 W Aqua UV plumbed in series with Sicce 2.0 pump
3 x Geissman Vervve lights on 80/20 extruded aluminum floating cantilevered rail.
The tank is 72"Lx 26"W x 22"H (165-gallon display) by Crystal Dynamics
Wavemakers are 2 x Octos 4 located in the back.
The skimmer is Octos REGAL 150sss and it's on a 3" lift to keep water level at 7.5" to 8" where we dial it in nicely.
4-part doser is a F4 Pro Kaomer.
2 x 300W Eheim heaters currently run on Inkbird controller.
Refugium light is Kessil a360 (I think that is the number)
We run 2 smaller AquaMaxx GFO in sump reactors.
Tunze ATO with a custom 13.5gallon acrylic reservoir by Advanced Acrylics.
I built the custom control box with 1/2" HDPE (high-density polyethylene). The back panel can be removed by latches (x4) to access all power supplies and cords.
I intend on building panels that sit and hold with magnets to the frame. These will likely be built on Christmas break. But I think it's clean enough of a set up to enjoy the open-view sump area now.
Our tank and sump carry 200gallons (+/- 5 gallons) after rock displacement.
Equipment:
2 x Various 6 pumps each with a devoted return.
40 W and 25 W Aqua UV plumbed in series with Sicce 2.0 pump
3 x Geissman Vervve lights on 80/20 extruded aluminum floating cantilevered rail.
The tank is 72"Lx 26"W x 22"H (165-gallon display) by Crystal Dynamics
Wavemakers are 2 x Octos 4 located in the back.
The skimmer is Octos REGAL 150sss and it's on a 3" lift to keep water level at 7.5" to 8" where we dial it in nicely.
4-part doser is a F4 Pro Kaomer.
2 x 300W Eheim heaters currently run on Inkbird controller.
Refugium light is Kessil a360 (I think that is the number)
We run 2 smaller AquaMaxx GFO in sump reactors.
Tunze ATO with a custom 13.5gallon acrylic reservoir by Advanced Acrylics.
I built the custom control box with 1/2" HDPE (high-density polyethylene). The back panel can be removed by latches (x4) to access all power supplies and cords.
I intend on building panels that sit and hold with magnets to the frame. These will likely be built on Christmas break. But I think it's clean enough of a set up to enjoy the open-view sump area now.
