Rate my RODI set up. Used for drinking water and DI

Joined
Nov 11, 2015
Messages
892
Likes
26
Points
28
#1
I'm going to set this up once my filters come in this weekend.

Pressure is forsure above 65. Need to check again

TDS from the wall: 550 ppm

Will contact water district about chloramines.

I was gifted 50, 1 micron sed filters so I'm using those until they're gone. Will use 0.2 after

Stage 1-4: 1 micron sed
Stage 5-6: 0.5 micron carbon
Stage 7: 75 gpd filmtec (550 ml flow restrictor)(I have an extra one that was cut for a 150 gpd membrane, which I may use as well)

Stage 8: may add carbon for taste

Dumps into RO tank/Faucet/Ice Maker

1/4th inch valve for when I make RODI.

Stage 9: DI

Thanks
 
Joined
Jun 22, 2013
Messages
2,591
Likes
99
Points
48
Location
Irvine
#4
So you're running two stages of carbon and then adding the last one for taste? Might be better adding a alkalinity stage to add back the minerals if you're using it for drinking water.
 

Dominic

New member
Joined
Dec 11, 2019
Messages
27
Likes
1
Points
1
#5
I run a very similar system and it runs fantastic now.
Where are you situated?
 

Latest posts

Top