Search results

My fear is if I do that wouldnt my alk raise too much and too fast. Sent from my iPhone using Tapatalk

Thats what I was thinking. Leaving the included pinch valve on the CaRx fully open and installing a needle valve inside the sump where the effluent line ends. Sent from my iPhone using Tapatalk

Manifold off my return pipe. I have the flow from the manifold turned down pretty low. Sent from my iPhone using Tapatalk

I was wondering if anyone can help me with this. My Aquamaxx CaRx, the C-Tech 1, seems to slow down after about two or three days. The output is going directly in to the tank. Any ideas or suggestions? Thanks.

My skimmer's effluent line keeps slowing down after a few days. Looking for a needle valve to see if that would help. Anyone have one for sale?

Apex ATK works well if you have an Apex. Sent from my iPhone using Tapatalk

Pm sent Sent from my iPad using Tapatalk

PM'd.

Pm

Nice. I? like the Filter sock concept. Sent from my iPhone using Tapatalk

I didn't realize I needed a "If Swx4_1 CLOSED Then OFF" My assumption was that once the float switch became "CLOSED" it would turn off the pump. What perplexes me further is the fact that the second float switch didn't turn off the pump.

This ATO config is driving me nuts. I have the following and it should work but it seems to always dump the entire content of my reservoir overnight. During the day it seems to be fine. This is what I have configured for the outlet. Fallback OFF Set OFF If Swx4_1 OPEN Then ON If Swx4_2...

Good deal. If you don

Anyone know where I can get some float switches with brackets? I need a second one for my sump. Possibly another for my ATO container and one for the skimmer. Thanks!

Looking for some basic SPS for now. Montipora Digitata Green w/ Purple Rim Monti Caps Ponape Birdsnest Anything else that is easy Preferably in the IE if possible. Thanks! Sent from my iPhone using Tapatalk

How old is the salinity probe. Tried to pm you but your box is full. Sent from my iPhone using Tapatalk

I have pure ammonia that I used to kick off the cycle. You only need a small amount. Sent from my iPhone using Tapatalk

Is it possible to split the water line that feeds my current RO unit to a second RO/DI unit? Also, can I tee off the waste line and use that for the new RO/DI unit as well? TIA Sent from my iPhone using Tapatalk

Nice collection. Sent from my iPhone using Tapatalk

Thanks. I don't make it out there that much. Sent from my iPhone using Tapatalk