Just picked this up, Had some problems at first there was 4 holes, 2 were plugged and glued closed so i had to rip them all out. Im guessing it was freshwater due to this config, 1 hole in left back corner and 1 hole in right back corner, and 2 holes kind of in the center of the tank. Ive never plumbed a tank before but im whilling to give this a shot if someone out there could guide me in the right direction.
For now ive cleaned the tank put all new bulkheads which corner are smaller then center bulkheads this is what im working with and not gonna try and re.drill.. How could i make this very useable? Im thinking i plug the 2 center holes and use the back left corner hole for intake to sump/can finter and have back right corner hole for water pump back into the tank from sump/can filter? Or possibly buy some acrylic sheets and make the two corners an overflow?
Feel free to chime in.
For now ive cleaned the tank put all new bulkheads which corner are smaller then center bulkheads this is what im working with and not gonna try and re.drill.. How could i make this very useable? Im thinking i plug the 2 center holes and use the back left corner hole for intake to sump/can finter and have back right corner hole for water pump back into the tank from sump/can filter? Or possibly buy some acrylic sheets and make the two corners an overflow?
Feel free to chime in.