I did my electronics today.
Fixed this mess.
First I setup a rio 2500 for a return pump and some temp heaters, I knew this was going to take a while.
Then I laid all the equipment out on the backer board and marked out where the holes needed to go.
After that I cut the holes, broke all the edges with sand paper and painted the board and upholstered the front of the board.
Next I mounted all the equipment to the front of the board.
Power supplies were velcro attached to the back of the board.
Made all the connections.
Then secured the board with screws to blocks that I had mounted inside the cabinet earlier.
There's still some touchup left but it's just about there.
Next project is to skin the stand.