Power head recommendation needed

[SC50964]

My tank side walls are 1" thick. Help is needed to identify what powerhead works on the 1" thick acrylic sheet. The desired flow rate is around 3000 gph.


Sent from my iPhone using Tapatalk

 

[KarL]

Mp60 and I've also used the large tunze magnets but would secure the pump wire to help hold

 

[All Delight]

mp60 will be good

 

[SC50964]

Thanks. Is there a cheaper alternative?


Sent from my iPhone using Tapatalk

 

[Paranoiattack91]

I like my gyre 150

 

[BeanMachine]

Thanks. Is there a cheaper alternative?


Sent from my iPhone using Tapatalk

I don't think cheap and a gazillion gallon tank belong in the same sentence Scott!

 

[SC50964]

Lol...., This isn't for the 560g, which I haven't made much progress after getting the sump made. It's for my current 125g coz the powerhead got burned up due to a small electrical accident. It's just for temp usage until I get the big tank up and running.


Sent from my iPhone using Tapatalk

 

[SC50964]

So I'm not looking to break the bank at all. Will a wp60 work?


Sent from my iPhone using Tapatalk

 

[KarL]

Jebao will work since they use suction cups too

 

[SC50964]

Jebao will work since they use suction cups too

Thanks. So wp60's magnet won't be strong enough but I can just use the suction cups.


Sent from my iPhone using Tapatalk

 

[KarL]

I don't think so. Jebao magnets are pretty weak. My tank is 3/4" and the outside jebao magnet can be pulled easily. The suction cup will hold the pump up though