just replaced all reagents with the ABC reagents for the first time. I used the old Neptune containers, just poured the contents into them. Easy peasy.
I made sure to prime all lines for the 3 reagents and the sample line.
started the calibration procedure.
I’ll let everyone know how it goes!
also did a little maintenance on the trident: I cleaned the internal vial- it was looking a little cloudy/dirty. It wasn’t hard, took about ten min or less. I didn’t realize how dirty it was. Probably why I had to calibrate almost monthly 🤦♂️. So hopefully this reagents work well. I think with a clean vial, primed lines and a calibration it should work as planned. But time will tell lol. I think I’m going to set reminder to clean vial out every 6 months- it’s been a few years in service- so it was probably way over due lol.