I just bought another tank :banghead: lol. 24" cube with mp10 and an ai sol lighting system.
My problem is that I can't get the controller to even turn on to change the programming that the previous owner had set up.
I have the power cord plugged in and the controller plugged into the data port. That is all that the system came with however after some research and initial frustration I was told that the USB port on the controller also needed to be plugged into the wall. I have an old black berry charger that fits in the USB port so I plugged it into the controller and wall and tried it to no avail. The LED back strip on the controller lights up blue for a second and then turns off. No writing ever shows up.
This is the controller with the single Knob. Any suggestions? Please help lol
Sent from my DROID BIONIC using Tapatalk 4 Beta
My problem is that I can't get the controller to even turn on to change the programming that the previous owner had set up.
I have the power cord plugged in and the controller plugged into the data port. That is all that the system came with however after some research and initial frustration I was told that the USB port on the controller also needed to be plugged into the wall. I have an old black berry charger that fits in the USB port so I plugged it into the controller and wall and tried it to no avail. The LED back strip on the controller lights up blue for a second and then turns off. No writing ever shows up.
This is the controller with the single Knob. Any suggestions? Please help lol
Sent from my DROID BIONIC using Tapatalk 4 Beta