3-D printing

[deaclauderdale]

Anybody doing any 3D printing? I need a small bracket or 2 made


Sent from my iPhone using Tapatalk

 

[joseserrano]

Try fishohex

 

[REPOWER]

Here’s one I’ve used in the past.

https://printed3d.parts/product-category/cradlesbrackets/

 

[BST310]

Anybody doing any 3D printing? I need a small bracket or 2 made


Sent from my iPhone using Tapatalk

I have a 3D printer. What do you need? Haven’t fired it up in a bit but not to hard to get going.

I designed this for another user on here.

 

[N2SWIMN]

Can you recommend a decent affordable 3D printer to be able to do stuff like this?

 

[BST310]

Can you recommend a decent affordable 3D printer to be able to do stuff like this?

Do you like to mess with stuff / solve problems etc? Or you looking for something to pull out of the box and print with little issue?

 

[N2SWIMN]

More of the latter, pull out and print. I new to this so will be learning.

 

[BST310]

More of the latter, pull out and print. I new to this so will be learning.

I’ll preface this by saying I’m not an expert by any means just a hobbyist. So I would recommend doing a little reading or watching a few vids before pulling the trigger.

I went with the Creality Ender 3 because of price it requires a bit of assembly out of the box. You also have to learn to level bed, work their programming, etc. It’s still a pain in the butt for me sometimes as it seems build quality can be hit or miss. There are users that set them up and print their hearts away and then users like myself that took some time to get things adjusted properly . But there are great FB groups that help walk you through any questions you may have.

Now for a machine, that from what I read just prints pretty darn good out of the box, look at the Prusa. Double the price roughly but I think I’d use my printer a lot more had I bought one of these units. They seem to just require less tinkering.

 

[brl0301]

I have a well setup/running printer that id sell you for cheap. Shoot me a pm if interested

 

[N2SWIMN]

I do some research and check out the videos as you recommended. I’ll also send brl0301 a pm to see what he has.

 

[jaxcarnage]

I have a 3D printer. What do you need? Haven’t fired it up in a bit but not to hard to get going.

I designed this for another user on here.
View attachment 94703

How much for 3 Neptune needle guides?

 

[Hugo’s_reef]

My Buddy has a few 3d printers and sells his stuff at a good price. Here are some things I got form him. He has plenty of inventory.

Here are just a few things I got xr15 light spill shields, vortech pump covers so you can run them higher in the tank without them sucking air in, ecotech controller mount, etc.

If anybody needs some he ships or you can swing by my place and scoop them up .


Hope this helps.


Sent from my iPhone using Tapatalk